If power fails, or you pull a filter or air stone out of the tank, water can run backwards along the airline into the air pump. Fluval’s manual covers how to prevent it: a check valve, a sensible pump position and the right order for removing the pump.

Quick answer: Fit a check valve in the airline between the pump and the tank. Don’t put the pump directly below the aquarium. When you remove the pump, take the airline off the pump outlet first, then unplug it. If you can’t take the airline off first, raise the pump above the water level.
Safety first: The manual warns that water back-siphoning into the pump can cause an electric shock. Unplug or switch off all appliances in the aquarium before maintenance.
This is based on the English section of Fluval’s A Series air pump manual (items A851, A853 and A854). Other pumps may differ, so check your own manual.
Why a check valve
The manual says it is highly recommended to always use a check valve (sold separately) in the airline between the air pump and the aquarium. The valve helps stop water siphoning out of the tank through the airline and into the pump if the power fails, or when you remove filters and other air-driven accessories from the tank.

Where to put the pump
The manual’s installation section recommends one of three methods:
- Place the pump on a surface lower than the water level of the aquarium.
- Place it on a surface higher than the water level. The surface should be at least 12 inches (30 cm) above the water level, but not directly above the aquarium, and it should have a raised edge so the pump can’t slide off.
- Wall mount it: hang the pump vertically with a nail or screw through its tab or eyelet.
Don’t place the pump directly below the aquarium. Accidentally spilled water could damage it. Keep it somewhere dry and relatively dust-free, and not on carpet.
A note on pump height
The manual’s safety instructions say that to prevent possible electric shock from water back-siphoning, the pump should be located higher than the water level. Its installation section also lists placing the pump on a surface lower than the water level. The two statements aren’t identical, and the manual recommends a check valve in every case. If you’re unsure which applies to your setup, contact Fluval.
How to set up the airline
- Attach one end of the airline tubing (item A1141, sold separately) to the air outlet on the pump.
- Attach the other end to a filter, air stone, ornament or other air-driven accessory. Make sure the airline has no restrictions or kinks.
- Plug the pump in, allowing for a drip loop in the cord.
How to remove the pump
Whenever you shut the pump off and remove it from the aeration system, take the airline off the air outlet before you unplug the pump. This prevents water siphoning back into the pump. If you can’t remove the airline before unplugging the power cord, raise the pump above the water level.
Quick reference
| Question | What the manual says |
|---|---|
| Check valve? | Highly recommended in every setup |
| Directly below the tank? | No |
| Above the water level? | At least 12 in (30 cm), not directly above the tank, on a surface with a raised edge |
| Wall mount? | Yes, vertically through the tab or eyelet |
| Removing the pump? | Remove the airline first, then unplug. If you can’t, raise the pump above the water |
Frequently asked questions
Do I need a check valve on my air pump?
Fluval’s manual says it is highly recommended to always use one in the airline between the pump and the aquarium. It helps prevent water siphoning into the pump.
When does back-siphoning happen?
The manual says it can happen if the power fails, or when you remove filters or other air-driven accessories from the aquarium.
How high should the pump be above the water?
If you place it above the water level, the surface should be at least 12 inches (30 cm) higher, but not directly above the aquarium, and it should have a raised edge.
Can I put the pump under the tank?
No. The manual says not to place the air pump directly below the aquarium, to avoid damage from accidentally spilled water.
What is the right order for removing the pump?
Take the airline off the pump outlet first, then unplug the pump. If you can’t remove the airline first, raise the pump above the water level.
What this page doesn’t cover
This page covers air pump equipment only. It doesn’t give fish-health, medication or water-chemistry advice, and it doesn’t describe electrical repair.
Sources and last verified
- Fluval, A Series air pump instruction manual, EU edition with English section (official PDF): fluvalaquatics.com
Last verified: November 19, 2026, against the English sections of the PDFs listed above.
