The AquaClear 110 comes with three kinds of media: Bio-Foam, activated carbon and BIOMAX. Fluval’s manual says how to rinse and place each one, and which way the water flows through them.

Quick answer: Rinse everything before use. Put the Bio-Foam in the bottom section of the media basket, lay both carbon inserts horizontally on top of it, then put both BIOMAX inserts on the third level. Then place the basket into the filter case.
Safety first: Unplug the filter before you put your hands in the water or take parts off. Don’t use soaps or detergents to clean the filter or media.
This is based on the AC110 edition of Fluval’s AquaClear AC Series manual. The media in other models may differ, so check your own manual.
How to load the media

- Rinse the Bio-Foam thoroughly and place it in the bottom section of the media basket.
- Take both activated carbon inserts out of their protective plastic bags. Rinse them thoroughly and place both horizontally on top of the Bio-Foam.
- Take both BIOMAX inserts out of their protective plastic bags. Rinse them thoroughly before placing both on the third level of the basket.
- Place the media basket into the filter case.
How water flows through the media
The manual says water enters the filter through the intake tubes and travels to the bottom of the filter case. It then passes through the Bio-Foam, carbon and BIOMAX before returning to the aquarium. When the flow control lever is at its minimum position, up to 50% of the water is recirculated for slower but more thorough filtration.
Cleaning and replacing media
- The manual recommends regular cleaning of the filter and its parts every month. Rinse in clear lukewarm water and don’t use soaps or detergents.
- The manual’s maintenance frequency chart lists these actions: Bio-Foam (check and clean, replace), BIOMAX (rinse, replace) and carbon insert (replace). Use the chart in your manual for the interval for each.
- If water spills over on the intake side, the manual says the media is likely clogged. Rinse it regularly to help prevent this.
- If flow is slower than normal, the manual says the media is likely dirty and in need of cleaning or replacement.
See our guides to low flow and the maintenance schedule.
Quick reference
| Media | Where it goes | Before use |
|---|---|---|
| Bio-Foam | Bottom section of the basket | Rinse thoroughly |
| Activated carbon (2) | Horizontally on top of the Bio-Foam | Take out of the bag and rinse thoroughly |
| BIOMAX (2) | Third level of the basket | Take out of the bag and rinse thoroughly |
Frequently asked questions
In what order do I put the media in an AquaClear 110?
The manual says Bio-Foam in the bottom section, the two carbon inserts horizontally on top of it, and the two BIOMAX inserts on the third level of the basket.
Do I rinse the media before use?
Yes. The manual says to rinse the Bio-Foam, carbon and BIOMAX thoroughly before use.
Can I use soap on the media?
No. The manual says not to use soaps or detergents when cleaning the filter.
Why is water spilling over on the intake side?
The manual says this is likely because the filter media is clogged and isn’t letting water pass through efficiently. Rinse it regularly.
How often should I clean the media?
The manual recommends regular cleaning of the filter and its parts every month. Its maintenance chart lists the intervals for each media type.
What this page doesn’t cover
This page covers filter equipment only. It doesn’t give fish-health, medication or water-chemistry advice, and it doesn’t describe electrical repair.
Sources and last verified
- Fluval, AquaClear AC Series instruction manual, AC110 edition (official PDF): fluvalaquatics.com
Last verified: November 19, 2026, against the English sections of the PDFs listed above.
