Fluval’s AC Series manual recommends regular cleaning of the filter and its parts, with some parts on a monthly, two-monthly or three-monthly schedule. This guide pulls those intervals into one place and shows the cleaning steps, based on Fluval’s official manual.

Quick answer: Clean the filter and its parts every month, rinse the intake sponge monthly and replace it every two months, and clean the motor thoroughly every three months. Don’t use soaps or detergents. The manual’s maintenance frequency chart lists other parts, such as the impeller, seal ring, Bio-Foam, BIOMAX and carbon.
Safety first: Always unplug the filter before you put your hands in the water or take parts off.
This is based on Fluval’s official manual for the AC Series (the AC110 edition), whose troubleshooting FAQ covers the AC20, AC30, AC50, AC70 and AC110. If you own an older AquaClear, check the manual that came with it.
The schedule at a glance

| How often | What the manual says |
|---|---|
| Every month | Regular cleaning of the filter and its parts is recommended |
| Every month | Rinse the intake strainer sponge (more often if your aquarium needs it) |
| Every two months | Replace the intake strainer sponge |
| Every three months | Thoroughly clean the motor |
The manual also has a maintenance frequency chart with monthly, two-monthly and three-monthly columns. It lists the impeller (check and clean), seal ring (check and clean), Bio-Foam (check and clean, replace), BIOMAX (rinse, replace) and carbon insert (replace). Use the chart in your own manual for the exact interval for each part.
How to do the monthly clean
- Always unplug the filter first. Remove the cover and the filter basket, and discard the water remaining in the filter case.
- Rinse the collected debris from the case, the impeller cover and the impeller assembly in clear lukewarm water.
- Clean the intake U-tube and extension tube with a filter stem brush to remove any buildup of deposits.
- When all parts are clean and thoroughly rinsed, reassemble the filter and put it back on the aquarium.
- Restart and prime it: fill the case with water, set the flow control lever to its lowest setting, plug it in and allow 30 to 45 seconds.
Don’t use soaps or detergents.
How to do the three-monthly motor clean
Follow the steps in our guide to cleaning the impeller and motor. In short, remove the motor with a gentle quarter turn, pull the impeller out of the impeller well, rinse it, use a cotton swab or impeller well brush for stubborn deposits, and reinstall the motor.
If something seems wrong
- Flow has slowed or water is spilling over on the intake side: see our low flow guide.
- The filter won’t start or prime: see our start and prime guide.
Frequently asked questions
How often should I clean an AquaClear filter?
The manual recommends regular cleaning of the filter and its parts every month, and a thorough clean of the motor every three months.
Can I use soap or detergent?
No. The manual says not to use soaps or detergents.
How often should I replace the intake sponge?
The manual recommends rinsing the intake strainer sponge monthly and replacing it every two months. More frequent rinsing may be needed depending on your aquarium.
Where is the maintenance chart?
It is in the maintenance section of Fluval’s AC Series manual. It lists parts such as the impeller, seal ring, Bio-Foam, BIOMAX and carbon with monthly, two-monthly and three-monthly intervals.
Do I need to prime the filter after cleaning it?
Yes. The manual says to follow the operating instructions to restart and prime the filter after cleaning.
What if my manual gives different intervals?
Follow your own manual. This guide is based on the AC110 edition of Fluval’s AC Series manual.
What this page doesn’t cover
This page covers the filter equipment only. It doesn’t give fish-health, medication or water-chemistry advice, and it doesn’t describe electrical repair.
Sources and last verified
- Fluval, AquaClear AC Series instruction manual (AC110 edition, official PDF): fluvalaquatics.com
Last verified: November 19, 2026, against the safety instructions, quick start guide, maintenance section and troubleshooting FAQ in that PDF.
