Water near a plug or socket is one of the most dangerous situations around an aquarium. Three manufacturer manuals describe it in the same way, and the steps are not what most people would do by instinct.

Illustration of a wall socket and plug with water drops beside a circuit breaker panel
Illustration, not a photo of a specific product.

Quick answer: If the plug or socket gets wet, don’t pull the plug. Switch off the fuse or circuit breaker that supplies power to the appliance. Only then unplug it and check the socket for water.

Safety first: The manuals label this a danger of electric shock. They say not to try repairs yourself and to return damaged equipment to an authorized service facility or discard it.

This is based on three official manuals: Eheim’s heater manual, Fluval’s AquaClear AC Series filter manual and Fluval’s A Series air pump manual. Other brands and models may differ, so always check your own manual first.

What to do if the plug or socket gets wet

Step-by-step checklist graphic: what to do if a plug or socket gets wet
Quick checklist. The full details are below.
  1. Don’t unplug the cord.
  2. Disconnect the fuse or switch off the circuit breaker that supplies power to the appliance.
  3. Then unplug the cord.
  4. Examine the socket for water.

Eheim’s US safety instructions and Fluval’s filter and air pump manuals all give this same order.

How a drip loop helps

A drip loop is the part of the cord that sits below the level of the socket (or below the connector, if you use an extension cord). It stops water that runs along the cord from reaching the socket. The manuals say to form one in each cord that connects aquarium equipment to a socket.

Eheim’s US safety instructions and Fluval’s air pump manual say to position the aquarium stand and tank to one side of a wall socket, so water can’t drip onto the socket or plug. Fluval’s filter manual says the same for the appliance.

If equipment falls into the water

For non-submersible equipment, such as the AquaClear filter and Fluval air pump, the manuals say not to reach for it. Unplug it first, then retrieve it. If any electrical part of the appliance gets wet, unplug it immediately.

If there is a leak or the RCD or GFCI trips

Fluval’s manuals say that if an appliance shows any sign of abnormal water leakage, or if an RCD or GFCI switches off, you should disconnect the power cord from the mains. For the filter, the manual also says to remove it from the water. Don’t try to repair it. Return it to an authorized service facility or discard it.

After installing equipment

Examine the appliance carefully after installation. The manuals say it should not be plugged in if there is water on parts that aren’t meant to be wet.

Quick reference

SituationWhat the manuals say
Plug or socket is wetDon’t unplug. Switch off the fuse or breaker, then unplug and check the socket
Non-submersible equipment falls in the waterDon’t reach for it. Unplug first, then retrieve it
Abnormal leak, or RCD or GFCI tripsDisconnect the power cord from the mains. Don’t repair it
Water on parts not meant to be wetDon’t plug it in

Frequently asked questions

Should I unplug a wet plug?

No. The manuals say not to unplug the cord. Switch off the fuse or circuit breaker that supplies the appliance first, then unplug it and check the socket for water.

What is a drip loop and where does it go?

It is the part of the cord below the level of the socket (or the connector, if you use an extension cord). It makes water drip off the cord instead of running to the socket.

Where should the tank sit relative to the socket?

Eheim’s US safety instructions and Fluval’s air pump manual say to position the stand and tank to one side of a wall socket so water can’t drip onto the socket or plug.

What should I do if the GFCI trips?

The Fluval manuals say to disconnect the power cord from the mains and not to attempt repairs yourself. For the filter, they also say to remove it from the water.

Can I fix a leaking appliance myself?

No. The manuals say to return it to an authorized service facility or discard it.

What this page doesn’t cover

This page covers electrical safety rules from manufacturer manuals only. It doesn’t give fish-health, medication or water-chemistry advice, and it doesn’t describe electrical repair.

Sources and last verified

Last verified: November 19, 2026, against the English sections of the PDFs listed above.

Related guides